DXF, DWG, Gerber 274X, 274D, Fire 9000 formats
DPF, HPGL, AI, Adobe EPS, PDF, CIF and GDSII
NIST traceable measurements
Per point charge
Assistance in tooling, layout and manufacturability
Etch and Fill and Circular Masks
Epoxy fill your patterns into the mask substrate
Lines as small as 100μm
Circular Masks– Cut to size
*2um features are achievable under certain circumstances
Pending a design review.
CUSTOM GLASS WORK
All processes and prices for custom cutting/grinding have been upgraded and are to be effective immediately for all customers (4/7/16).
All cut pieces will be square/rectangular with a ± 1.000mm (± 0.040 in) border
Mask layouts require square regions with 2mm spacing and 5mm mask edge border
Edges and corners will not be ground/chamfered unless ordered
All cutting orders with more than 36 cuts (5×5 layout) will require a special quote
Minimum piece size of cutting/grinding capability is approximately 1cm x 1cm
All edges will be flat Unless chamfered edges are ordered
All orders with non-standard shapes or sizes will require a special quote
All layouts will be created by Front Range PhotoMask and will attempt to maximize the useable surface area and number of pieces per plate.
Order turnaround may increase by one day per every 10 pieces ordered